Page 2 of 2
Re: HELP
Posted:
February 2nd, 2014, 2:51 pm
by Retta
Guess what it worked with Inkscape to Signcut. My plugin for CS6 must be bad Do you know where I can get it?
Thyme
Re: HELP
Posted:
February 2nd, 2014, 3:00 pm
by Thyme
From the Signcut site, or by reinstalling Signcut
Re: HELP
Posted:
February 2nd, 2014, 3:03 pm
by Retta
Okay! Thanks again
Re: HELP
Posted:
February 2nd, 2014, 3:59 pm
by Suzan
USB 2 ports are grey, USB 3 are blue. Also make sure you have the right plug in for your computer. And make sure it is the one installed in AI. And you may have to run it as admin.
Re: HELP
Posted:
February 2nd, 2014, 6:40 pm
by pigtailpat
usb 3 ports should be backwards compatible with a device that is 2.0. It just won't operate at 3.0 speed. At least, this was my experience with 2.0 ---1.0.
Pat
Re: HELP
Posted:
February 2nd, 2014, 8:39 pm
by Elizabeth
Glad you got to cut something, Retta! I'm no help with computer issues. Glad that Dawn and others were here to help!
Re: HELP
Posted:
February 4th, 2014, 7:02 am
by Retta
So am I Elizabeth I I keep forgetting the reset. Once MTC could cut I knew keyspan worked. It turned out to be the plug-in for adobe Illustrator.. You do have to freak if it isn't working. What a relief to get Dawn's help! By the way , Hope you are doing well! Hugs Honey!
Re: HELP
Posted:
February 4th, 2014, 11:11 am
by Elizabeth
Hugs back at ya,
Retta ! I'm terrific. Looking forward to lots of snow this week. It's been a very pretty winter in New England! Hope you are well, too!
Re: HELP
Posted:
February 4th, 2014, 5:07 pm
by Retta
Yes overall I'm doing well. Blessed more than I can say! Thank-you