On the Learning center the page below shows the settings to use.
http://blackcatus.com/learn/?page_id=1035
When I upgraded my Signcut and Inkscape I was online with Signcut support and had issues re installing everything. My settings are below, I noticed the handshake is different but I have o option to change
I export from inkscape to signcut with no problem. The when I hit cutout it shows a message really quick, so quick I can't even read it and just does nothing after that. Any suggestions? I re-installed the driver for the cutter in case there was a USB/COM issue but nothing...
Of course I am trying to get a xmas gift done I don't know what it is not working.......... Any advice is much appreciated!!!