Silver Bullet Cutters Forum

Okay,
I have installed my Black Cat and Signcut over.

I am trying to do the manual calibration. When I go into special cutting/contour cut, my
arrows will not move the laser to the registration marks.

Is there someone that can help.

Lindalou

I did it. I figured out why my arrows were not working.

The settings in the menu box - The XP and YP were off and the BR way way off!!!!!!

I am now calibrating. Cross your fingers ladies. I actually may succeed!!!!

That's great -good to hear!!

I am now finally calibrated! Amen.
I was so ready to take a hammer to it all.

Thank Goodness I continued.

Thanks to all who have tried to help.

Lindalou

Perseverance will get you there - almost always!!

Good luck with your contour cutting - you should be well skilled by now!! And be sure to write down you x and y numbers somewhere so if you lost the program again for any reason, you will be able to plug those numbers back in and won't have to recalibrate.