Hey, Everyone. I'm trying to cut vinyl on my Cougar with 24 inch vinyl using Signcut. I cut 3 pieces vertically that are about 24-30 inches long and 6 in. wide. So, I cut three pieces at about 6 in., then I cut the last one down to size to fit the rest of the 24 in. The cut starts, but then the machine pauses. I make sure the mat size is OK on Signcut, but I just can't get that last piece to cut. I'm sure it's something simple, but I can't figure it out. I'm left with a 5-6 in. wide piece that I can use later (I cut all of them off at the end so I don't have to re-load the vinyl), but it makes batch cutting somewhat difficult.
Waiting for Hurricane Sandy to make her appearance in Southeast PA. My biggest concern is to get a bunch of vinyl cut for my vendor shows before we have a power outage. Ha.
Fondly, Tami