by Gigi » August 31st, 2012, 7:10 pm
Retta wrote:Well it stopped hitting the wall. So I didn't have the MM set right. I changed the settings after I set to MM too. So okay. Now I got to cut. But the crazy thing is - the box it is cutting is outside the registration marks and much bigger than the one that I have on the print and in the file. I'm losing it. I know!!!
Thanks!
No you are not losing it. I had the same problem and I am trying to remember what happened. Dawn had to help me with it - darn it's been a while. I think it was something that had changed in the software of Signcut.
Since I can't remember (and will keep thinking...) lets start with the cutter settings. Do yours look like this??
You do not have the required permissions to view the files attached to this post.
Silver Bullet Admin/Tech Support
Happily using an 24" Silver Bullet Platinum
Gigi