I am so frustrated! I upgraded Signcut to 1.95 and it would not cut dashed lines and also forget about PNC, so Dawn suggested I revert back to the previous edition, I did. I added it to Norton so that would not be an issue, I installed it again from the link in the BC manual here. Now I export from inkscape to Signcut and when I hit simple contour cut it stops working and closes it. I checked and it says version 1.07 which is the previous. Shows my reg number fine. Any ideas? I am with my two little ones today trying to get an anniversary card out for DH and I am running out of patience with the computer cause I would rather finish this card and play with my babies instead of fighting this issue!!!!
Thanks!!!!!!!!!!!!!!!!!!
IT erased info on com port and also the laser registration mark size and had "tile" checked, working now!