Does anyone else have this problem?
I design in SCAL3. I do lots of subway art, so my design often has about 15 or more words on a piece of 8" by 22" rectangle. When I cut it with Signcut (I use vinyl for this), I can never be sure if it's going to cut the entire design. It will often cut about 10 words, then it will stop. The carriage doesn't go back to the origin. I can always tell when it hasn't finished, even when I'm somewhere else in the house, because I don't hear the carriage go back to the origin.
That means that I have to cut out the second "half" on another piece of vinyl, and I can't take advantage of the weeding lines (which are uber helpful with my big vinyl projects).
It's getting to where I almost have to design my subway art in halves, because I know Signcut won't finish. I could cut it in MTC, but then I can't use the weeding lines feature of Signcut.
Any suggestions?
Fondly, Tami