Silver Bullet Cutters Forum

Hi Everyone

I am looking into purchasing a new computer but want to have everything in line so I can keep cutting non-stop after I get set up and running. So, that being said...if I remember right there is a certain download for the USB Driver so the computer and the machine can connect with each other...where do I find this download for MTC and my 24" BCC?

Also...Is that all I will need with a complete new laptop setup? ...Just a Reinstall of MTC and the driver download? Or is there something else I am missing?

Thanks so much for any help!
Katie

I don't use MTC, but the download for the program is on their website. The drivers for your machine can be found in the BC Learning Center.

http://blackcatus.com/learn/?page_id=2183

That should help you I hope.

You will need to download the plug-in from MTC also. I use the knk plug in. Otherwise yup that is all you need

Thanks for the help everyone!

OK. So I have no idea what my username & password are for the BC Learning Center as I haven't been on there in a long time. Do you know if there is any way to retrieve this...or could I just create a new account?

Thanks again
Katie

Katie -

I am PMing your username for the BC Learning Center. Once you have that you can reset your password on your own - so watch for a PM in a minute!!