MTC and Cougar USB Driver??

MTC and Cougar USB Driver??

Postby KT Krafter » September 27th, 2013, 8:22 pm

Hi Everyone

I am looking into purchasing a new computer but want to have everything in line so I can keep cutting non-stop after I get set up and running. So, that being said...if I remember right there is a certain download for the USB Driver so the computer and the machine can connect with each other...where do I find this download for MTC and my 24" BCC?

Also...Is that all I will need with a complete new laptop setup? ...Just a Reinstall of MTC and the driver download? Or is there something else I am missing?

Thanks so much for any help!
Katie
KT Krafter
 
Posts: 41
Joined: December 2nd, 2011, 7:50 pm

Re: MTC and Cougar USB Driver??

Postby Gigi » September 28th, 2013, 12:26 am

I don't use MTC, but the download for the program is on their website. The drivers for your machine can be found in the BC Learning Center.

http://blackcatus.com/learn/?page_id=2183

That should help you I hope.
Silver Bullet Admin/Tech Support


Happily using an 24" Silver Bullet Platinum

Gigi
User avatar
Gigi
 
Posts: 10432
Images: 190
Joined: May 14th, 2011, 9:53 pm
Location: Southern California
Cutter: 18" Silver Bullet Pro, Foilmaster

Re: MTC and Cougar USB Driver??

Postby minorcustomcrafts » September 28th, 2013, 1:20 pm

You will need to download the plug-in from MTC also. I use the knk plug in. Otherwise yup that is all you need
minorcustomcrafts
 
Posts: 126
Joined: May 15th, 2011, 11:01 am

Re: MTC and Cougar USB Driver??

Postby KT Krafter » September 28th, 2013, 3:22 pm

Thanks for the help everyone!

OK. So I have no idea what my username & password are for the BC Learning Center as I haven't been on there in a long time. Do you know if there is any way to retrieve this...or could I just create a new account?

Thanks again
Katie
KT Krafter
 
Posts: 41
Joined: December 2nd, 2011, 7:50 pm

Re: MTC and Cougar USB Driver??

Postby Gigi » September 28th, 2013, 7:07 pm

Katie -

I am PMing your username for the BC Learning Center. Once you have that you can reset your password on your own - so watch for a PM in a minute!!
Silver Bullet Admin/Tech Support


Happily using an 24" Silver Bullet Platinum

Gigi
User avatar
Gigi
 
Posts: 10432
Images: 190
Joined: May 14th, 2011, 9:53 pm
Location: Southern California
Cutter: 18" Silver Bullet Pro, Foilmaster


Return to Make The Cut!

Who is online

Users browsing this forum: No registered users and 2 guests

cron