MTC Question

MTC Question

Postby Everett » February 3rd, 2012, 8:17 am

Back again!! Question is; If I purchase SignCit w/my machine, can I still use MTC if I want to????
Everett
 
Posts: 9
Joined: February 1st, 2012, 8:41 am

Re: MTC Question

Postby Elsa » February 3rd, 2012, 8:18 am

Yes!
User avatar
Elsa
 
Posts: 220
Joined: May 15th, 2011, 8:11 am
Location: North Central Texas
Cutter: 13" Black Cat Cougar

Re: MTC Question

Postby Angel135612 » February 3rd, 2012, 9:06 am

Yes, you can use any software you choose to at any time.
Diane in Colorado Springs
The best angle from which to approach any problem is the try-angle.
User avatar
Angel135612
 
Posts: 3038
Images: 7
Joined: May 14th, 2011, 7:51 pm
Location: Colorado Springs CO
Cutter: 24" Silver Bullet

Re: MTC Question

Postby Everett » February 3rd, 2012, 9:14 am

That's great!!!!! That re-leaves my biggest concerns about what to buy. You people in here are great, Thank You so much!
Everett
 
Posts: 9
Joined: February 1st, 2012, 8:41 am

Re: MTC Question

Postby allandra42 » February 3rd, 2012, 4:15 pm

Yes I use Make the Cut the most. I have also used signcut some and Corel some. You can use them all which is one of the many reasons the cougar is the best machine!
Hours spent in my craftroom are considered by me "Time Well Spent"
Please visit my blog: http://timewellspentbylesa.blogspot.com/
User avatar
allandra42
 
Posts: 873
Images: 21
Joined: May 15th, 2011, 12:54 pm
Location: Kentucky
Cutter: 15 inch Cougar, 24 inch Silver Bullet

Re: MTC Question

Postby iggylover » February 5th, 2012, 10:19 pm

Just remember to not have multiple software programs open at the same time and try to cut... they compete for the machine and get somewhat grumpy about it.
iggylover
 
Posts: 507
Joined: June 29th, 2011, 6:46 pm
Location: Southern California


Return to Make The Cut!

Who is online

Users browsing this forum: No registered users and 4 guests