Hello,
I've been using my cougar since 2012, with a USB mac.
Everything was going well.
I used it less because I started printing in 3D.
I wanted to reuse my cougar, but nothing is going right now.
A few months ago, he cut the small files correctly, but at times he randomly blocked on the left and came back by making stepped cuts to the right without wanting to stop with a bad noise.
I just tried to use it again, but now
- It cuts very slowly, forgetting curves
- It systematically cuts the same piece two to three times
I tried to change the USB cable, the computer (including the old one it worked with), the SCAL version (3, 4 and 5)
Nothing: always inaccurate and duplicate cuts.
How to redompt my cougar?