I have a Cougar using SCAL4 and Windows 7. I cannot get it to print.
I go through the setup and everything works normally. I do a test connection and the machine responds. I hit "cut" and nothing happens. If I go through the print & cut routine, I will get the message "data sent to cutter" and the machine will go into Pause state. Pressing the pause key (or any others) does nothing. I power it off & restart and get the same result.
I have tried to check comm ports per another thread, but my menu does not list any comm ports; only the USB ports.
Has anyone had this experience where the machine simply does not respond to the cut command? I'm sure I'm overlooking something simple and will consider myself a total idiot when I finally get it to work.
Thanks,
Mike