Page 1 of 1

Overlapping cuts...possible wheel issue?

PostPosted: February 4th, 2016, 11:53 am
by Education
Hello! Our Black Cat cutter has recently started to overlap the shapes when cutting even though our shapes do not overlap on the template in the Sure Cuts A Lot software. One of our wheels has become super sticky and when moving the mat the machine makes a horrible and loud sound. We are thinking we may need to replace a wheel because it is unable to move the mat properly, but the overlapping still occurs even when that wheel is not touching the mat. (We have used smaller mats to avoid the use of that wheel, but the overlapping still occurs.) Has anyone else had this issue of overlapping cuts? Any advice would be much appreciated! Thanks!

Re: Overlapping cuts...possible wheel issue?

PostPosted: February 14th, 2016, 4:06 pm
by PennyDuncan
Hello Education.....I can't say I've encountered the issues you are experiencing before.....I would suggest contacting Dawn at Thyme Graphics....she is still in the UK... and see if she has any suggestions for you.