Silver Bullet Cutters Forum

After doing a cut, I looked at my screen and saw this:


I turned my machine off and back on and the screen was back to normal. Has this happened to anyone else? Is it something I should worry about? I sure hope it was a one time deal and not the start of problems.

I would be tempted to say it might be the motherboard - I have not seen anything like that. But the fact that it came back up is good. If it happens again, I would do a machine reset and see if that resolves it. I might do it anyway.......

There might be others on here who own a Lynx and have seen something similar and am sure they will comment if they have.

Thanks, Gigi.

Did it help? If it persists, I would contact Sherri at thatsscrapinc@aol.com