Lynx is misbehaving...again - RESOLVED

[peoriagrammy]

OK Ladies, I'm back again! Today, I cut a design perfectly. Then on the second cut (no changes made to design) the "arm" went over to the left side and rubbed against the side of the machine. Yes, I set origin to "0", I also turned the machine off and unplugged it to see if that worked but it didn't. Any suggestions would be appreciated! BTW I have a Lynx. TIA for your help!

[peoriagrammy]

Well, I turned it off and walked away for about an hour. It then cut the next 5 beautifully. This machine is tempermental!

[Elizabeth]

Glad it started working again for you. I find that restarting my software often solves this kind of problem.