Need Help installing cutting blade

[Dorrine]

I am unable to access the learning center and need help finding videos/tutorials on how to install the cutting blade on the Black Cat Lynx. Can anyone help?

[Thyme]

If you cannot access the learning centre then you need to contact Sherri with your purchase details and ask for access.

[Dorrine]

Thank you Thyme. I have been told I'm not eligible for membership. I purchased this item used through Ebay and it was purchased through That's Scrap, Inc. and am trying to resolve this with Sherri and the seller. I found my user manual and it is difficult to understand since it's written very poorly in English. I was able to get the machine working, however, there is no laser light working although everything else appears to be fine. I still am puzzled as to how far over to insert my paper into the machine, am still playing around with this trying to figure it out. It would be so much easier if the laser worked.

[Thyme]

You would only use the laser for print and cut - not for any other operation.
Set your paper about 1/2 inch in from the right hand side if you need the full cut width