by Gail » May 10th, 2013, 11:10 pm
I got it finally! It was skewing by 1/4 on the 10" side. I always use my cougar mat that came with the machine. As for the wheels, I keep my right wheel on the mat edge, one going down the middle, and one on the left side of my 12x12 paper and they are lined up with the red marks. Is that considered too close? With 8 1/2 x 11, I lift the last one. But for this project, my speed and force were way too high for the rectangle even though I had used these settings on something much smaller and it cut fine. So, I lowered it considerably and it cut fine. Thanks so much.