Looking for the Calibration file for Print and cut RESOLVED

[JensMom]

I am at the learning center and I wanted to calibrate my Cougar. On the video there is a link to All That Jazz which is supposed to have an MTC calibration file, on the video it looks to be some sort of black paper with a cut out. I did a search on the site and can't find it, the only file is a Circus File. Does anyone know where I can get the calibration file? Thanks

[colleen]

Jen; If you go to the Cougar Manual. Then settings, then to the calibration page. Just under the picture of all the blades it says download pdf. That is the one that you want. It has numbers on it and is easier then the oiginal all black one by rob. I think you may have just past over . The circus file is on the very bottom. Here is the link. http://www.blackcatus.com/learn/install ... ration.pdf

[Gigi]

Here it is - just searched for it.

[JensMom]

Perfect, thanks so much everyone. Now wish me luck.

[Elizabeth]

Good luck! Once you get the calibration done, Print and cut is easy peasy. I have been using it more and more lately, and I love it.