blade housing hitting right side of machine repetitively
Posted:
February 9th, 2013, 4:08 pmby Prussc
Was trying to learn to use the pen today with a 12 x 12 paper and a 10x7 card I designed in inkscape. Using Scal 3.046 to draw and cut. Trials worked okay and then when I put in the good paper the housing when returning after cutting kept hitting the right side of the machine and I couldn't stop it. Hit the reset, turned the machine on and off but again when I wrote it seems to want to go further right. What setting am I forgetting?
Re: blade housing hitting right side of machine repetitively
Posted:
February 9th, 2013, 5:12 pmby MaryP
You need to ensure the screws on the pen holder are facing forward or they will hit to righthand side of the cutter. HTH
Re: blade housing hitting right side of machine repetitively
Posted:
February 9th, 2013, 5:53 pmby Prussc
Oh duh!!!! That's exactly what was wrong. Thank you
Re: blade housing hitting right side of machine repetitively
Posted:
February 10th, 2013, 12:52 amby MaryP
LOL. I wonder how I knew that!
