Help Please

[reneas72]

My Cougar keeps pauses during cutting any thoughts on why ??

I'm using MTC program

[Gigi]

Even though you have a 24" - is the cutting area going out of range? (mat should be all the way to the right). Does your design have too many nodes? I think MTC pauses if it's too intensive. Is it pausing at the same place every time?? Just a few starter questions...

[Tyler]

If it is starting/stopping/starting during cutting and has a lot of nodes/points in it, it is because MTC is trying to send it data.

If it is pausing and staying paused until you have reset the machine, it is likely due to you going out of its range...here is the section that should help in the Learning Center:

http://blackcatus.com/learn/?page_id=579/#cutting_bay

[reneas72]

not sure what I did wrong but hubby got it to work

Thank you everyone