Angel135612 wrote:What software are you using?? Is your blade the right height? Did you brayer your paper down well onto the mat?? Could the paper be getting "picked up" by the blade, causing it to cut into your design?
Even though it is different letters, is it happening in the same place on the mat or in the cutting area of the machine? I know my machine didn't like one area, and it wouldnt' cut all the way through, but raising the blade holder to 2 CD height instead of one helped with that problem. Not sure it if will help with yours, but it would be worth a try.
Not sure what else to check.
rachellann wrote:What version of scal3 I believe 3.27 is the latest if you don't have that version please update.
newbiecat wrote:By any chance have you overlapped the letters as in this ?
If so you need to select both and check the box that says weld on the right side under appearance
hope this helps
Pandora
Suzan wrote:I know it would be a pain, but could you cut one letter, and then the other. See if that helps.
Return to Black Cat Lynx/Cougar
Users browsing this forum: No registered users and 23 guests