Lynx cutting yesterday but not today

[Kilakila]

Hi everyone. Brand new to the forum and brand new to the Lynx cutter. This is going to be one long learning curve. Particularly as I've started off on a bad note, it seems. Just doing some general practice cuts yesterday. Everything was good. Today I tried again, and nothing happened. Lynx does the test cut okay and the SCAL software says it is sending file to the machine, but that's it. Uninstalled and then re-installed software. Unplugged USB and power cable. Still nothing.

Please help, because I have so many ideas running in my head, and I want to learn how to work this darn machine before I go crazy!

[rachellann]

ok one thing to check is make sure you are on line when cutting and make sure it shows the correct port.

[Thyme]

Also try a factory reset in case you have accidentally altered the Br rate

[Kilakila]

Definitely online when attempting to cut. Port never changed, but thanks for the feedback. Something to keep in mind in future, thanks Rachellann

Hmm, Thyme, you might be correct. I think I may have been pressing buttons and changed the Br rate. Will attempt this fix after breakfast!

I have a feeling I may be on here quite a few times!

[Kilakila]

Thanks Thyme - your fix worked!

[Suzan]

OMG I feel so bad, I was going to suggest that, but didn't know the baud rate for the Lynx. Next time I will make sure i do.

[Thyme]

Glad its sorted!